VIDEO
Installing and Calibrating the Ring Roamer Touchscreen
Step-by-Step Instructions
Step 1: Clean the iPad Screen
Clean the iPad screen using a microfiber cloth to ensure there are no debris particles present.
Step 5: Reattach the back cover
Align the standoff with the screw holes.
Install the screws, but only halfway at first.
Once all screws are in, fully tighten them, ensuring they are hand-tightened without over-tightening.
Step 2: Orient the iPad correctly
Ensure the camera is positioned at the top.
Ensure the charging port is at the bottom.
Step 6: Calibrate the touchscreen (if necessary)
Locate the spring-loaded pressure points designed to prevent screen damage.
Use the provided Allen wrench to adjust the set screw pins:
Turn counterclockwise to loosen.
Slowly tighten clockwise until the spring lifts slightly.
Repeat the process for all six pressure point spots.
Note: There is an additional hidden pressure point in the middle, but it typically does not require adjustment.
Step 3: Install the iPad
Place the iPad into the Ring Roamer, ensuring it is properly seated and lies flat against the glass surface.
Step 7: Test the touchscreen
Touch each corner icon to ensure it responds correctly.
If any area is unresponsive, locate the nearest pressure point screw pin and tighten it as needed.
Step 4: Prepare the back cover
Locate the provided USB-C charging cable.
Connect the charging cable to the iPad.
Tuck the cable carefully to avoid pinching when closing the cover.
Important Notes
When you received the Ring Roamer, the touchscreen was pre-calibrated. Only recalibrate if you experience issues such as dead spots.
Avoid over-tightening screws, as this can damage components.
If you have further questions or require additional support, please contact our customer service team.
Thank you for using the Sapphire Ring Roamer!
